Cowl Fitment

[landy]

So I took off the cowl to clean the collected debris underneath out. Installed an aftermarket debris screen underneath the cowl and put the cowl back on. However, on the edge next to the bottom of the windshield, it sticks up a bit. It seems like it should fit closely next to the windshield, but mine has a gap and sticks up a bit. I don't remember if it was like that before removal. There are what look like two bolt holes on either end of the cowl and in the body piece beneath, but no captive nuts so maybe bolts didn't go there? Seems like a couple of bolts are needed to bring the edge of the cowl down close to the windshield.

How do others' cowls fit in this area? Do they have bolts in these two holes? Pics would be helpful.

Thanks!