|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-13-2012, 08:35 PM
|
#26 |
|
Senior Member
 
Join Date: May 2011
Location: Cypress, Tx.
Posts: 1,504
|
Re: Rear axle identification and driveshaft?
I went to get my driveshaft today, about 25 minutes there and 25 back. the driveshaft was nice, new front u-joints too and it was painted too! I was excited and went to install it immediately, but the darned thing was too short! By 1 3/4"! I took it back, he measured it and said with a puzzled look, "I don't know how I did that!" Anyway, it's not like I'm going to go drive it immdiately! lol I pick it up tomorrow~ again.
__________________
'72 Ford Bronco project(July 17 2021-?) https://67-72chevytrucks.com/vboard/...d.php?t=828015 59 Apache (sold 6-25-2021) 67 Ford Mustang (re-restored after Harvey) 1968 Jeep Cj5 (2-8-2020 to present) 1992 Jeep Yj (8-17-20 to present) (Jurassic build) www.Classiccarsandtools.com |
|
|
| Bookmarks |
|
|
Threaded Mode