1" Engine Stand Spacers on 60-62s

[robber grin]

Alright I get it that the frames are different heights and a one inch spacer must be used to upgrade to the small block side mount stands.

I got some 1 x 1 bar stock and will attempt to make that work.

QUESTION - My drivers side mount's frame location seems to be right over my factory frame VIN stamp and I don't want to drill through or damage that area - in fact I'd rather not cover it either.

Anyone else run into this or am I just that lucky?

I had considered making that spacer long enough to mount at some point past the VIN stamp but it would still cover the numbers once installed.

Thanks guys...