Turn Signal Switch Install with plug already on - The 1947 - Present Chevrolet & GMC Truck Message Board Network

gipper · 12-21-2012, 08:47 PM

Hello all, I have a 1968 GMC Stepside that is almost completely restored. I just got an original steering wheel and figured while I was at it, I might as well replace the turn signal switch as the exsisting one was cracked where the turn signal lever screwed into it.
I wanted a switch that had the original red knob and not the black reproduction. Only this new harness came with the plug already attached to the wires. I see no way to thread this back thru the column! Can someone help me out please?

12-21-2012, 08:47 PM	#1
gipper Registered User Join Date: Dec 2010 Location: Fruitport, Michigan Posts: 172	Turn Signal Switch Install with plug already on Hello all, I have a 1968 GMC Stepside that is almost completely restored. I just got an original steering wheel and figured while I was at it, I might as well replace the turn signal switch as the exsisting one was cracked where the turn signal lever screwed into it. I wanted a switch that had the original red knob and not the black reproduction. Only this new harness came with the plug already attached to the wires. I see no way to thread this back thru the column! Can someone help me out please?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.