FL 383 Stroker/Sid Neal Turbo 350/Supercharger

[Hart_Rod]

**** New price $4250!!!!!***

I'm selling the motor, tranny and Vortech supercharger setup out of my 1968 Chevy C10. This engine was built by T&L Motorsports out of NC. The engine by itself produced around 450 HP. It dynod 631.1 TQ @ 4900 rpm and 622.7 HP @ 5400 rpm with a Vortech V2 supercharger (see below). The run was only to 5500 rpm, but the engine is built to go to 7500 RPM. Motor and tranny have less than 10K miles on them and you can hear it run and ride in it if you so desire, . There are a couple of videos in my build thread also.

**** VIDEO ****

http://s852.beta.photobucket.com/use...65363290758454

*************
What's in the motor/tranny:

383 stroker motor (1 piece rear main seal)
All forged internals
9:1 Compression
Carrillo forged crank and rods
SRP pistons

Dart Pro 1 Platinum 200 aluminum heads with roller rockers, chamber port volume 69, intake port volume 200, 2.02 intake, 1.6 exhaust, 3425 springs, PBM seals, CompCam pushrods in/exh 7809-16
PRW Stainless steel roller tip rockers (1.5 3/8)
Competition cam - XR276HR-12
----Operating Range:1800-5800
----Duration Advertised:276° Intake/281° Exhaust
----Duration @ .050'':224° Intake/230° Exhaust
----Valve Lift:.503° Intake/.510° Exhaust
----Lobe Separation Angle:112°

MSD billit mechanical distributor (blue/silver springs 36 degrees)
MSD 6BTM ignition box with adjustable boost retard and 6K rev limiter
8MM wires
High volume oil pump
Miloden 8qt oil pan
Aluminum water pump and pulleys
LOKAR transmission and engine oil dipstick
fluid harmonics dampner
Edelbrock Performer RPM HPC coated intake
SS headers (1 3/4" primaries) custom built for 67-72 Chevy's (they do not hang below the frame)
High torque starter
motor mounts
All accessories and brackets are included

Sid Neal TH350
SFI flexplate
2800 stall torque converter
Aluminum deep pan cover

Asking $4750 for complete motor tranny and all accessories - minus the carb and supercharger. IF you want the entire package inluding the Vortech Blower, the following components will be included:

Vortech V2 Supercharger (8" crank pulley)
QFT 750 BAN Blow through carb
Aeromotive boost adjusted FPR
MSD 6BTM ignition box with adjustable boost retard and 6K rev limiter
50 mm Blow-off valve

Asking $9,000 for the complete setup.