AL Short fleetside bed, frame and cab for sale - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**JQ-72** · 01-09-2013, 11:50 AM

I'd like to sell all this stuff together, but if no interest I'll separate.

* Fleetside bed - Bed sides are arrow straight with no bondo. P.O. installed checker-plated steel in floor. Metal floor is not rusted through, but does have some visible dents from the bottom side. One rust spot on left rear (pic). $700

* 1970 cab - rockers already removed and small section of floor at kick panel area has been cut out (about 6"X6"). One cab support has a few small holes, the rest are perfect. Visor area is pretty nice, one very small pin hole. Cab corners look good. Roof is good, firewall is good. Pretty nice cab. $400.

* 1970 swb frame - matches VIN on above cab. Frame is perfect! No bends or welds on it. Sport bumper brackets. 3.73 open coil rear end. Manual crossmember has been cut out and set up for auto. P.O. said it had all new brakes, but I can't guarentee. I do see new rubber lines on it. Original 6-lug set up. $400

I'll take $1,300 for ALL of it including 2 doors and 2 fenders. Doors and fenders are restorable condition.

Thanks.
Joshua

01-09-2013, 11:50 AM	#1
JQ-72 Senior Member Join Date: Feb 2001 Location: Killen, Alabama USA Posts: 3,628	Short fleetside bed, frame and cab for sale I'd like to sell all this stuff together, but if no interest I'll separate. * Fleetside bed - Bed sides are arrow straight with no bondo. P.O. installed checker-plated steel in floor. Metal floor is not rusted through, but does have some visible dents from the bottom side. One rust spot on left rear (pic). $700 * 1970 cab - rockers already removed and small section of floor at kick panel area has been cut out (about 6"X6"). One cab support has a few small holes, the rest are perfect. Visor area is pretty nice, one very small pin hole. Cab corners look good. Roof is good, firewall is good. Pretty nice cab. $400. * 1970 swb frame - matches VIN on above cab. Frame is perfect! No bends or welds on it. Sport bumper brackets. 3.73 open coil rear end. Manual crossmember has been cut out and set up for auto. P.O. said it had all new brakes, but I can't guarentee. I do see new rubber lines on it. Original 6-lug set up. $400 I'll take $1,300 for ALL of it including 2 doors and 2 fenders. Doors and fenders are restorable condition. Thanks. Joshua Attached Images __________________ 72 Cheyenne Super swb. Factory 402/400,tach,posi,AM/FM, A/C. Adding cruise, 8-track 72 Cheyenne Super swb. 350/350 A/C, bucket seats 72 Cheyenne swb. Factory 402/400, tilt, posi, A/C 72 Cheyenne Super K-10. 350/4 spd., posi. 72 Suburban 350/350 tilt, tach, AM/FM, A/C, luggage rack 72 GMC Sierra lwb. 350/350, A/C. medium green/olive interior



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.