Tranny finish - The 1947 - Present Chevrolet & GMC Truck Message Board Network

DanoDMano · 10-30-2003, 10:12 PM

I am getting ready to pull my motor and tranny to do some engine Mods and to replace my leaky front tranny seal and torque convertor.

My question is, What is the best finish for my motor and tranny that I can apply in my garage? I want the motor to be orange, kinda like my truck in my avatar. I am also either wanting my tranny to be silver, or from what I have been reading, the original aluminum finish with a clear coat.

What are your recommendations as far as finish? I have seen alot of your engines on this board am always impressed on the way they look. I will have to use rattle can, and am wanting to know the best stuff to use?

Thanks for any help!!

10-30-2003, 10:12 PM	#1
DanoDMano Pronounced "Pew-al-up" Join Date: Oct 2002 Location: Puyallup, Washington Posts: 845	Tranny finish I am getting ready to pull my motor and tranny to do some engine Mods and to replace my leaky front tranny seal and torque convertor. My question is, What is the best finish for my motor and tranny that I can apply in my garage? I want the motor to be orange, kinda like my truck in my avatar. I am also either wanting my tranny to be silver, or from what I have been reading, the original aluminum finish with a clear coat. What are your recommendations as far as finish? I have seen alot of your engines on this board am always impressed on the way they look. I will have to use rattle can, and am wanting to know the best stuff to use? Thanks for any help!! __________________ Classic GM Trucks of Washington Club Member 1970 FS chevy,350/350, Edelbrock cam and intake. Holley 650 carb,HEI,AT,Tangier Orange, 18's, Power Locks, Truck Photos



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.