Drive Shaft Install - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JR Dean · 01-16-2013, 04:51 PM

Recently I installed a 350 SBC into my '63 GMC. When it was time to connect the driveshaft back up, there was not enough clearance to make the connection. I need about 1/16" more space. I remembered that when the engine mount stands were put in place that the mounting holes were lotted. It appears that if the 3 bolts holding each stand in place are loosened that the engine could be moved forward far enough to allow the drive shaft to be fastened in place. Am I on the right track?

01-16-2013, 04:51 PM	#1
JR Dean Registered User Join Date: Jan 2013 Location: LaVale MD Posts: 17	Drive Shaft Install Recently I installed a 350 SBC into my '63 GMC. When it was time to connect the driveshaft back up, there was not enough clearance to make the connection. I need about 1/16" more space. I remembered that when the engine mount stands were put in place that the mounting holes were lotted. It appears that if the 3 bolts holding each stand in place are loosened that the engine could be moved forward far enough to allow the drive shaft to be fastened in place. Am I on the right track?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.