|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-10-2003, 10:47 PM
|
#1 |
|
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Gas Gauge question (again)
I tried a search, but couldn't find what I was looking for. My gas gauge worked fine after the blazer tank install (well, 3/4 tank= full, and under empty means empty). Well, I took the gauges out to paint the backs white for brightness reasons, put it all back together installed it, and now I get under empty for 1/2 tank, and almost no movement when full (I went and filled her up to make sure I wasn't crazy and out of gas). I unplugged the sending wire @ the fuse block and te auge went to full. What does it all mean?? Is the gauge supposed to go to full when open?? Is the resistor on the back supposed to go a certain direction? besides left to right? Once again, any help is greatly appreciated!!!Tanks,
Shawn
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
|
|
| Bookmarks |
|
|
Threaded Mode