03-02-2013, 03:23 PM | #1 |
Registered User
Join Date: Jan 2010
Location: Forsyth, Ga
Posts: 1,012
|
Cluster wiring
This might should go in the electrical section however it is specific to these trucks so figured I would ask here. I have a 67 pickup that had a no guage cluster. I have since added gauges to this and now it is time to wire.
The new temp and oil gauges are electric, my question is can I use the factory wires that used to go to the dummy lights as the wires that now would be sending the signal? Ie can i take the wire from the old sensor, hook it to the new sensor then under the dash run that wire to the new gauge. It may be a smiple question, just did not not know if the wires were of a resistance type like the coil wire where you have to change it out to power hei ignitions. Thanks in advance. |
Bookmarks |
|
|