|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-24-2013, 11:58 PM
|
#1 |
|
Registered User
 
Join Date: Dec 2012
Location: Chandler AZ
Posts: 1,149
|
Need to install new master cylinder but the piston depth is diff
I am finishing up the drum to disc conversion on the truck. I have a question about the depth in the back of the master cylinder piston. The old MC has one that is about 3/4" deep while the new has just a dimple. Will I be OK just screwing the push rod tip in all the way or should I go another route?
I stop fine now but could it be better??? Thanks in advance, Vince
__________________
1970 Longhorn, Front Disc, 350/4 bolt, 882 heads, HEI, Edelbrock, 700R4, HO-52/4.11. 1996 Corvette, Collector Roadster, LT4, 396, 450RWHP, 6sp, 4.11/Dana44/posi 5 point roll bar And let us not grow weary of doing good, for in due season we will reap, if we do not give up. Gal 6:9 |
|
|
| Bookmarks |
|
|
Threaded Mode