Project truck dream 65"

[lenguini]

So,the Air condenser is finally mounted.I opted for this style unit as it has top and bottom mounting which eliminated stress on the condenser tanks.

I left adequate room to run my trans cooler in behind it,as I did not want to run it up front.I used a thread setter and installed the thread plugs in the original cross bar holes....,also separated and used the original cross bars as well.

The spacing is within 1/8 of an inch on top and bottom so up close all is concentric. I will be using 90 degree coupled elbows as the outlet side is limited for space now.

All is nice and square ! My good buddy Chopper approves.

A special thanks to Darcy L. for his expert abilities and keen eye.