|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-17-2003, 01:26 AM
|
#11 |
|
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Here comes the hard part. Drill 2 holes in the lip of the hole on the fender (where the light goes) These will be used to mount the hinges in place. While your at it drill the holes on the opposite side also. These holes will be used to hold on the plastic fuel tray.
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
|
|
| Bookmarks |
|
|
Threaded Mode