|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-23-2013, 12:16 PM
|
#1 |
|
DiablosWeldingFabrication
Join Date: Jun 2009
Location: Elverta ,CA
Posts: 201
|
Drive Shaft a after Bagging
I'm about to start welding my step notch and also going to install porterbuilt trailing arms..my question is what are you guys best recommendation on drive shaft? should i go with 2 piece? or stay with on piece?. I had a couple of friends with 2 piece and all i herd were complaints. I'm not afraid to cut or fabricate the cab or crossmember.
 Posted via Mobile Device |
|
|
| Bookmarks |
|
|
Threaded Mode