|
06-02-2013, 11:21 PM
|
#1 |
|
Registered User
Join Date: Apr 2011
Location: Clifton, CO
Posts: 76
|
NP 205 Help me...
I'm putting new gaskets in my 205 while I've got it out for a clutch swap. All was good until I took off the rear output and the 15 needle bearings inside the output shaft got out. Is it just a matter of being patient and sticking them back with vasoline? The washer and snap ring that keep them there make it tough for a guy with fat fingers. If not is there another trick I can't find? It doesn't look like there is any access except from the front...
I need this back together ASAP. Any help is appreciated. Posted via Mobile Device |
|
|
| Bookmarks |
|
|
Threaded Mode