NP 205 Help me... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

B_derK20 · 06-02-2013, 11:21 PM

I'm putting new gaskets in my 205 while I've got it out for a clutch swap. All was good until I took off the rear output and the 15 needle bearings inside the output shaft got out. Is it just a matter of being patient and sticking them back with vasoline? The washer and snap ring that keep them there make it tough for a guy with fat fingers. If not is there another trick I can't find? It doesn't look like there is any access except from the front...

I need this back together ASAP. Any help is appreciated.
Posted via Mobile Device

06-02-2013, 11:21 PM	#1
B_derK20 Registered User Join Date: Apr 2011 Location: Clifton, CO Posts: 75	NP 205 Help me... I'm putting new gaskets in my 205 while I've got it out for a clutch swap. All was good until I took off the rear output and the 15 needle bearings inside the output shaft got out. Is it just a matter of being patient and sticking them back with vasoline? The washer and snap ring that keep them there make it tough for a guy with fat fingers. If not is there another trick I can't find? It doesn't look like there is any access except from the front... I need this back together ASAP. Any help is appreciated. Posted via Mobile Device



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.