How do the rubber cab mounts go? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**1971Stepside** · 11-29-2003, 11:41 PM

Lost Wages gave me a set of radiator support and cab mounts (rubber) but I can't figure out what goes where.

I have the radiator support figured out I believe. It uses a smaller diameter rubber and has flat rubber (rather than coned) pieces for the bottom.

On the cab I have two different thickness rubber pads. Do the thicker ones go in the front or the back of the cab? All four have the coned pieces for the bottoms.

I would like to set the cab back on the frame tomorrow, but I need to know how these go first. Any help would be greatly appreciated.

11-29-2003, 11:41 PM	#1
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,932	How do the rubber cab mounts go? Lost Wages gave me a set of radiator support and cab mounts (rubber) but I can't figure out what goes where. I have the radiator support figured out I believe. It uses a smaller diameter rubber and has flat rubber (rather than coned) pieces for the bottom. On the cab I have two different thickness rubber pads. Do the thicker ones go in the front or the back of the cab? All four have the coned pieces for the bottoms. I would like to set the cab back on the frame tomorrow, but I need to know how these go first. Any help would be greatly appreciated. __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.