07-12-2013, 01:46 AM | #1 |
Registered User
Join Date: Jul 2008
Location: Concord, CA
Posts: 194
|
Leaning
My 72 2wd Blazer is sagging on the rear driver's side. I looked at the coil springs and on the passenger side, there is about a 2" gap between the top coin and the next. About the same between coils 2 and 3. After that, everything is compressed. On the driver's side, there is a gap between the top 2 coils, the rest are collapsed onto one another. I'm sure that these coils were cut by the PO. Could it be that the driver's side is sagging because it was annealed by a torch during cutting? I've had this truck for a couple of years and I just noticed this condition.
|
Bookmarks |
|
|