Can someone measure a t-case please - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Scrub · 12-01-2003, 12:26 AM

Jose came by a few days ago to pick up a t-case. Only problem was the darn thing wasn't drilled out for the big bolts on the side mount. Anyone know why? anyway, I decided to use the case myself and I am drilling and tapping the holes, but I need to know how deep I can make them without blowing into the case.

Could someone measure the depth of the two side mount holes on a 205 t-case for a 72 k 20. Your will have to have a 205 laying around to do this.

I also need to know the size of the bolt. I think it is a 9/16 bolt.

Thanks in advance

12-01-2003, 12:26 AM	#1
Scrub Collector of rusty Items Join Date: Dec 2001 Location: Sisters,Oregon USA Posts: 731	Can someone measure a t-case please Jose came by a few days ago to pick up a t-case. Only problem was the darn thing wasn't drilled out for the big bolts on the side mount. Anyone know why? anyway, I decided to use the case myself and I am drilling and tapping the holes, but I need to know how deep I can make them without blowing into the case. Could someone measure the depth of the two side mount holes on a 205 t-case for a 72 k 20. Your will have to have a 205 laying around to do this. I also need to know the size of the bolt. I think it is a 9/16 bolt. Thanks in advance __________________ Scrub Sisters, Oregon - Home of the Sisters Rodeo. 70 GMC 1,000,000 + miles 72 K-20 project, 456 Dana60 front, Corp14 rear w/locker, 265R19.5 tires 20-ply. Warn 12k winches both ends, Cross-over steering with raised tie-rod, Powerbox steering, 4500 watt 120-AC power, Air, Hydraulic aux power, 4 inch lift, 5000 lb air-bags both ends.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.