Drop spindle question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Hybridcx · 07-31-2013, 09:10 AM

Hello everyone,
I picked up a set of belltech's 3120 drop spindles real cheap last week. I have a 72 GMC 1/2 ton (2wd) and it would seem these are ment to fit that year chev/gm. My issue is when I went to install them my outer pitman (edit tie rod ends) arms were too small. I did a bit of digging and figured out I needed C20 pitman arms (tie rods). Does anyone know why this is? Is this typical? I just want to make sure this isnt going to cause me issues down the road. Thank you -Matt

07-31-2013, 09:10 AM	#1
Hybridcx Registered User Join Date: May 2012 Location: Abbotsford B.C Posts: 26	Drop spindle question Hello everyone, I picked up a set of belltech's 3120 drop spindles real cheap last week. I have a 72 GMC 1/2 ton (2wd) and it would seem these are ment to fit that year chev/gm. My issue is when I went to install them my outer pitman (edit tie rod ends) arms were too small. I did a bit of digging and figured out I needed C20 pitman arms (tie rods). Does anyone know why this is? Is this typical? I just want to make sure this isnt going to cause me issues down the road. Thank you -Matt Last edited by Hybridcx; 07-31-2013 at 09:22 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.