2 piece driveshaft - slip joint seal replaceable? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JellyBeanDriver · 08-01-2013, 01:38 AM

86' Dually C30, TH400, 454, 2 piece driveshaft with center bearing.

Replaced the 2 u-joints on the rear driveshaft section after first unbolting it from the diff, then pulling it loose from the center slip joint. The seal in the center slip joint tore out.

I greased up the splines real well when I put it back together but would like to replace that seal as the slip joint opening faces forward to catch dirt/debris.

Is this seal replaceable? Where would I get one?

08-01-2013, 01:38 AM	#1
JellyBeanDriver Registered User Join Date: Jul 2012 Location: United States Posts: 268	2 piece driveshaft - slip joint seal replaceable? 86' Dually C30, TH400, 454, 2 piece driveshaft with center bearing. Replaced the 2 u-joints on the rear driveshaft section after first unbolting it from the diff, then pulling it loose from the center slip joint. The seal in the center slip joint tore out. I greased up the splines real well when I put it back together but would like to replace that seal as the slip joint opening faces forward to catch dirt/debris. Is this seal replaceable? Where would I get one? __________________ 86' C30 Dually Crew Cab Ranch truck, carb'd 454, TH400, towing a slant load 4 horse trailer.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.