|
09-10-2013, 03:07 PM
|
#1 |
|
Senior Member
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
flexplate gaps?
when installing my new transmission i noticed that there is about 3/8 or more gap between the flex plate and the converter, I usually use flat washers to shim it up when I bolt them together, should I use fly wheel shims?
And what is the normal gap between the flex plate and converter I don't want to pull it forward to much or cause my flex plate to warp tighten it down? 168 tooth fly wheel, TH350 tranny
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
| Bookmarks |
|
|
Threaded Mode