TX '64 Under Way

[CMFT]

What's going on guys? New guy here, like many, watched the forums for a long time, but finally joined up once I was ready to pull the trigger on a C10. After searching for a good driver, I found this truck locally and pulled the trigger. It needs work, like most of them do, but really happy with my starting point.

A few specs:

1964 St. Louis built
Big back window
350 under the hood with a Turbo 350 tranny
Edelbrock intake
Holley 4 barrel
Fresh paint - Charcoal gray and cherry red
Interior is fairly stock, less a B&M shifter, which will be replaced in the future

This will be a driving project, as I refuse to do anything that will take it off the road long term:

Chrome side trim molding
Get it lower to the ground - starting with springs/spindles, bagging later down the road
Power steering and brakes
Disk brakes
Re-locate gas tank under bed
Re-wire entire truck
New wheels - likely nostalgic
Rear chrome bumper
LED's front and rear - I like to be seen on the road
After all of the above, will move on to a modern fuel injected motor. Hoping for an LS1, but there is a 5.3L lingering in our group right now that may need a new home.

Haven't had a chance to get pic's with my good camera, so here's what you get for now...