TX '65 Short bed chassis bagged with Porterbuilt

[red02chevy]

I was building a truck for a customer and he lost interested in the project. We striked up a deal and I ended up with the chassis. The plan was to find a clean truck to buy and build with this chassis but I have too much going on right now. Located in Lubbock, TX.

-The good-
'65 short bed chassis
'71 5 lug rear end (unsure of gear ratio)
'85 front cross member, control arms
'73-'87 3" Belltech drop spindles for 1.25" rotors
New ball joints, new control arm bushings included but not installed
New rotors, bearings, seals, dust caps, hardware
Porterbuilt Stage 1 front suspension
Porterbuillt Stage 2 basic rear suspension
2" drop blocks
All rivets removed and replaced with 7/16" grade 8 hardware (to match Porterbuilt parts)

-The bad-
Cab mounts had some rust where the bushing goes, I have them but didn't install them. I wanted to find a cleaner set or fabricate some. They are definitely use able but were not up to my standards.
No rear brakes
I don't have a set of wheels for it. The Cragars were pulled off another build. I believe I have another set of steel 15" wheels so if purchased we would just need to figure something out on tires.

Asking $2250 as is. That basically covers parts and makes labor free.