|
11-11-2013, 11:53 PM
|
#1 |
|
Registered User
 
Join Date: Nov 2007
Location: Vernon, Texas
Posts: 331
|
disc brake spindle
I ran into a little snag on rebuilding my front end. It a 67 c10, the spindles I'm using are a 71-72 disc brake, all the tie rods( and the center link are 71-72. The problem i ran into is the outer tie rod shank doesn't seem long enough. With it seated in the spindle, the hole for the cotter pin is just a hair below the spindle, even when torqued down. Ive mic'd the tie rod and everything seems right. Any suggestions?
  
|
|
|
| Bookmarks |
|
|
Threaded Mode