Cut off tool stalls under load - The 1947 - Present Chevrolet & GMC Truck Message Board Network

msg · 11-25-2013, 05:35 PM

I know that you get what you pay for but I was not aware of how it stalls under load. Its a Harbor Freight cheapie http://www.harborfreight.com/3-inch-...ter-47077.html.

I'm running it on a 5HP 80 gallon air compressor at 90psi.

Am I not operating the tool right or is there a better tool someone could recommend that wont cost a bunch that will not stall?

Took me 20 minutes to cut a 3ft long cut on a 18 GA door panel.

11-25-2013, 05:35 PM	#1
msg Registered User Join Date: Feb 2013 Location: GA Posts: 1,325	Cut off tool stalls under load I know that you get what you pay for but I was not aware of how it stalls under load. Its a Harbor Freight cheapie http://www.harborfreight.com/3-inch-...ter-47077.html. I'm running it on a 5HP 80 gallon air compressor at 90psi. Am I not operating the tool right or is there a better tool someone could recommend that wont cost a bunch that will not stall? Took me 20 minutes to cut a 3ft long cut on a 18 GA door panel.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.