Tech Help - What more do I need to lay low?

[Vetter]

Need some tech support -

I have a 67 LWB, 4-wheel drum, 6 lug, no power-steering - on a bcfab.com air ride. I am looking to install the CPP Rear C-Notch Kit and I have a set of cupped LCA's on order (fab'd and bought from another forum member). I have had a custom 2 piece drive-shaft built and installed, but I am wondering what else I will need to get the truck to lay-out without any additional problems. I am looking to go low budget without converting to disc and adding drop spindles.

* Do I need to order an adjustable Panhard Bar?

* Do I need a Flip Kit or adjustment on my Carrier Bearing, or a whole new CB Center-Support/Crossmember?

* Are there any adjustments needed up front? (The steering center link already seams to rub the front crossmember when aired out and making sharp turns.

Any additional info and support will be greatly appreciated.

Thank you.