|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-18-2003, 11:52 PM
|
#1 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
Pinion seal replacement
Is replacing the rear pinion seal a pretty straightforward job? It looks like I just need to drop the u-joint, mark the nut, remove the nut, remove the yoke, r+r the seal and reverse the procedure. Does the yoke come off easily? Does the seal come out and go in easily? Is putting the nut back to the same spot the thing to do, or should I measure preload, do the procedure, and reset preload to the same as before?
Just never messed with it before, thanks.
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
| Bookmarks |
|
|
Threaded Mode