Drove truck went to start back up and wouldn't - The 1947 - Present Chevrolet & GMC Truck Message Board Network

SCHRUMGMC · 01-06-2014, 05:35 AM

I went to start the truck "turned over fine" but then when I had drove it to a neighbors the truck wouldn't start back up.We charged it and it did fine and then cut off again.I know the Plugs,wires and Generator are all good I am thinking it is the Voltage regulator because of it still being the original one that came out of the Factory.The carb is slowly leaking gas at the housing but as far as I know it was re-built

Its been doing wonderful before all of this

Sorta confused on all of this

01-06-2014, 05:35 AM	#1
SCHRUMGMC Registered User Join Date: Dec 2012 Location: North Carolina Posts: 4,989	Drove truck went to start back up and wouldn't I went to start the truck "turned over fine" but then when I had drove it to a neighbors the truck wouldn't start back up.We charged it and it did fine and then cut off again.I know the Plugs,wires and Generator are all good I am thinking it is the Voltage regulator because of it still being the original one that came out of the Factory.The carb is slowly leaking gas at the housing but as far as I know it was re-built Its been doing wonderful before all of this Sorta confused on all of this __________________ 1971 GMC Sierra 1959 GMC 100 Last edited by SCHRUMGMC; 01-06-2014 at 05:58 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.