IA Oil line fitting that screws into rear of block

[LockDoc]

-
I have a few new fittings that screw into the oil pressure port on the GM blocks. It’s for the 1/8” line that goes to the oil pressure gauge. These fittings have the compression cap nut on them as you can see in the picture. Some oil lines have this type and some have the sleeve nut as shown in the fourth picture. If your line has the sleeve nut on the engine end of the line you can still use this connector by cutting off the sleeve nut and sliding the cap nut and compression sleeve onto the line. This fitting includes the three pieces as seen in pictures 2 & 3. They are $5 each + $1.50 postage, until postal rates go up on the 26th, then the postage will be more… PayPal or Money Order works for me.

Per board rules post in thread before sending any PM's

Thanks,
LockDoc