exhaust help... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

draggin49 · 02-01-2014, 08:52 PM

So I'm not an exhaust guy, so looking for input from those more knowledgeable.

I just picked my truck up, simple setup, dual 2.5" from my headers, to turn downs before the rear axle. Well I was recommended to this shop, the owner (who I thought was doing the job)
Wasn't there today, an employee of his was only one there. When I dropped the truck off I thought the guy was simply opening up the shop , it was 9am, when the place opens.

Some stuff just looked odd to me

Driver side header/flange/exhaust
Almost mated up at a 90 degree

Passenger side

Behind muffler where turndown is

There are hardly any bends required i got under and looked.its straight back through the crossmember.

02-01-2014, 08:52 PM	#1
draggin49 Registered User Join Date: Feb 2013 Location: Ojai, CA Posts: 356	exhaust help... So I'm not an exhaust guy, so looking for input from those more knowledgeable. I just picked my truck up, simple setup, dual 2.5" from my headers, to turn downs before the rear axle. Well I was recommended to this shop, the owner (who I thought was doing the job) Wasn't there today, an employee of his was only one there. When I dropped the truck off I thought the guy was simply opening up the shop , it was 9am, when the place opens. Some stuff just looked odd to me Driver side header/flange/exhaust Almost mated up at a 90 degree Passenger side Behind muffler where turndown is There are hardly any bends required i got under and looked.its straight back through the crossmember. Last edited by draggin49; 02-01-2014 at 08:58 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.