Mounting Tahoe third row seats - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Hugh Mongus · 02-20-2014, 10:31 AM

Removed the bench seat brackets and attached 1.5" 1/8" wall tubing on the front with 1/8" angle on the rear to maintain the correct seat angle.

The seats give more leg room and set the driver back a little more from the steering wheel. They are more comfortable compared to the bench seat.

Pulled it back out so I can mount a Kicker solo-baric 10" sub in the center. I will fab a console around the sub so it cannot be seen.

02-20-2014, 10:31 AM	#1
Hugh Mongus Registered User Join Date: Jan 2014 Location: Tulsa, OK Posts: 360	Mounting Tahoe third row seats Removed the bench seat brackets and attached 1.5" 1/8" wall tubing on the front with 1/8" angle on the rear to maintain the correct seat angle. The seats give more leg room and set the driver back a little more from the steering wheel. They are more comfortable compared to the bench seat. Pulled it back out so I can mount a Kicker solo-baric 10" sub in the center. I will fab a console around the sub so it cannot be seen.



Register or Log In To remove these advertisements.