Crusty Rusty Leaky Squeaky 67 Step

[Vic1947]

Today, I dollied out as many dents as I could get to on the bed floor then flipped it over to begin fixturing the sections. I'd bought a new front panel this past fall and when I pulled it out of the box, it was seriously twisted. So I made a panic trip to Classic Parts and exchanged it for one that was only bowed along the bottom lip. Brian G. is coming over tomorrow to help me use the shrinker to straighten it out. Hate working on brand new parts, but the counterman was real upfront and said it wouldn't be likely to find a perfect one.

The initial fit on the driver side looks pretty good, even without using any butt clamps. Need to trim a little in a few places to get a closer fit, but it should be no problem. You can see the offset between the body lines in the last photo. Not as bad as I'd envisioned, but it will still be an interesting exercise to make it 'flow" seamlessly.