|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
12-29-2003, 11:25 PM
|
#1 |
|
Registered User
Join Date: Sep 2003
Location: Twin Falls, Idaho
Posts: 73
|
GM steering shafts needed
I have an old Crown bus that I'm making into an RV. The steering wheel is 22.5 inch diameter. The wheel spline is very different than any others. I have cut the shaft and need a GM shaft to change to GM steering wheels. I'm gonna use a factory Chevy pickup 16 inch wheel.. My buddy brought to me a tilt wheel shaft from a buick. The shaft is too short. I need about 3 of these shafts. The shaft needs to be about 12-15 inches long. Here in Idaho, there are not a lot of shafts available. I will pay a fair price and shipping... My addy is...
frank-id@velocitus.net... My Crown bus project.. below.
__________________
Chevy stepper 400sb 350 turbo Last edited by Frank-id; 12-29-2003 at 11:37 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode