oil pressure gauge (copper line)

[cherokeejohn]

So last nite, after a long cold,nasty, winter, I finally installed my replacement trans. While I was getting it filled with ATF properly, I sat back in the drivers seat to check my temp gauge I noticed my leg felt strangely warm, and wet. When I turned on my int. light i saw that my right leg was soaked in oil along with my shoe and the floorboard. once I saw it was oil (immediately) I shut her down. I knew right away what had happened. So after all the headache of the trans swap. I was in the final steps to try it out, but Nooooooo!, I didn't even get to take it out of park. I'll order it today, the only one I found for a replacement oil press. line is LMC for $20. My question to anyone who can help is; What options do I have to delete this line. I plan on installing a electric gauge, along with others at same time. So can I just buy a elect. sensor and just use that as a plug until I get the new gauges, or should I just bite the bullet and replace the line? Opinions, Suggestions, anyone? thanks John