'Wintergreen' 1969 GMC Build

[rusty_67]

For sure Barry, give me a call, I've got a decent amount left.

Not too much to update. Pulled the airbags off and installed there fittings then started running the lines.



Had the rad support, battery tray, etc sand blasted then gave them a coat of paint. Here is the rad support installed.



Started to layout the engine wiring harness. Wanted to make sure everything fit properly. Unfortunately it was close but no cigar. The wiring harness was made to work for the impala/camaro/firebird LT1 and since I had upgraded to the corvette accessory bracket, some of the electrical components, mainly the ignition module/coil, had jumped to the opposite side of the engine. So I had to rip apart my nice new wiring harness to fix that. So that's done know, but I still need to install all the sensors on the engine to make sure everything else is good.