![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Sep 2009
Location: Weare,NH
Posts: 1,591
|
DIY: Center console install
I see this question asked often on the boards. Thought I would pass along a discovery I made when installing my center console this week.
What you need: OEM console from a Suburban/pickup, the rear bracket and the 6 screws to hold it down. You also need a drill with a 3/16" bit and a 10mm socket. At first I thought I would have to make measurements to install the suburban console. Not so. ![]() GM provided divets in the floor pan to drill the holes. I lined up my console and the divets lined up. Awesome! Drill a couple 3/16" holes here. For the rear holes, you need the bracket from the donor truck. The rear divets are less obvious, I used a sharpie to highlight them. ![]() The little silver dots in the middle. drill these out as well. Install bracket. ![]() and then install console. ![]() This was to install a 1989 console in a 1986 truck. Different years of console and truck may vary. |
![]() |
![]() |
Bookmarks |
|
|