67 C20 LB Conversion to C10 SB Fleet.

[mr.chevy]

Originally Posted by robozride

Im thinking of doing this to mine soon and have some ?'s how big is the air space between the outer and inner bed side? how did you lay out to get your lines the same inside and outside? the job your doing looks really good and will probably inspire me to take mine on.

Wow guys I feel really bad and didn't know that you had asked me a question. I am glad to answer anything.

I know there was some space I just used a grinder with a cut off disk and was careful not to get to far in. I'm not sure exactly how I measured it. It has been a while. But i can say that I measured a lot and used squares and a chalk line.

again so sorry i didn't answer. I haven't been on here in so long.