Wiring an Aftermarket Washer Pump

[LSUMurse]

I looked at multiple threads and never really "saw" what I was looking for. Using this method, there is zero cutting on your wiring harness. I do much better with pictures, so here's what I did:

Pic #1 - The dark blue wire is the negative and the yellow wires are the positive. This connection is to the stock washer pump. Slide a small screwdriver between the plastic of the boot and the terminal to be able to slide the terminals out of the boot.

Pic #2 - Crimp on some insulated blade terminals to the black and white wires of your washer pump (Blue would probably work better, but I only had yellow). Connect the blue wire to your negative wire on your pump (in my case black) and yellow wires to the positive wire on your pump (mine was white). I put a little extra electrical tape around the fittings to make sure I didn't have a short.

Pic #3 - Prime and mount your pump. I got ghetto and wire tied mine to the wiper motor. I didn't want to mount it in the engine compartment and not sure where I really want it to go. It is quite loud.

Pic #4 - Eureka!!!! The single stream of water coming out is quite comical. (I don't know why my computer flips pics)