window regulator roller holes - The 1947 - Present Chevrolet & GMC Truck Message Board Network

HBlue · 06-01-2014, 10:07 PM

I'm upgrading a 78 Silverado. I ordered replacement rollers and more stuff from LMC. The roller they sent me has a shaft that measures 3/16" and is made to rivet onto the old regulator.

I drilled, ground and punched out the old rollers, and found the hole is 1/4". I found a plastic sleeve that would take up the slack space, but I don't think the rivet will spread enough to make a good tight seal.

Anybody got any suggestions?

06-01-2014, 10:07 PM	#1
HBlue Registered User Join Date: May 2014 Location: Louisiana Posts: 28	window regulator roller holes I'm upgrading a 78 Silverado. I ordered replacement rollers and more stuff from LMC. The roller they sent me has a shaft that measures 3/16" and is made to rivet onto the old regulator. I drilled, ground and punched out the old rollers, and found the hole is 1/4". I found a plastic sleeve that would take up the slack space, but I don't think the rivet will spread enough to make a good tight seal. Anybody got any suggestions?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.