Driveline geometry help... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

FLYNAVY30 · 06-12-2014, 03:13 PM

I have the engine installed using CPPs tubular motor mounts and a crossmember from BMR Hot Rods on the 4L60E trans. Right now, the driveline angle is -9 degrees. From what Ive ready, I want to be somewhere between -3 and -5 degrees. Any thoughts on options? I was thinking of just adding a metal shim to two to the poly mount on the crossmember to raise the tail end of the transmission up a bit as theres plenty of room in the tunnel. Any input would be greatly appreciated.

Thanks!

06-12-2014, 03:13 PM	#1
FLYNAVY30 Registered User Join Date: Apr 2013 Location: Austin, TX Posts: 592	Driveline geometry help... I have the engine installed using CPPs tubular motor mounts and a crossmember from BMR Hot Rods on the 4L60E trans. Right now, the driveline angle is -9 degrees. From what Ive ready, I want to be somewhere between -3 and -5 degrees. Any thoughts on options? I was thinking of just adding a metal shim to two to the poly mount on the crossmember to raise the tail end of the transmission up a bit as theres plenty of room in the tunnel. Any input would be greatly appreciated. Thanks!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.