![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Aug 2006
Location: Redmond, WA
Posts: 6,332
|
Sensor (oil, temp) issues
I'm having two issues. 1970 402.
a) I cannot for the life of me figure out where the temp gauge sender goes. I know it had one because the gauge didn't work, and I checked its resistance. I just don't remember where it was, have no photo of it, and the assembly manual shows it at the water neck. That I -do- have photos of and it wasn't there. b) On the oil side, I have the oil pressure tube connected to the center hole of the three that are available above the oil filter on the big block. I cannot, however, seem to thread the idiot light sensor (blue wire) into the little hole. It looks like the same size, but maybe there's paint in it, or it's not a tapered thread, or some difference, or LMC sent me a metric thread sensor. I'm out of ideas. Similarly, I'm going to have to plug whichever plug hole I don't use, and I don't know what'll fit. And tips welcome!
__________________
1970 GMC Sierra Grande Custom Camper - Built, not Bought 1969 Pontiac 2+2 427/390 4-speed Coupe 1969 Pontiac 2+2 427/390 4-speed Convertible |
![]() |
![]() |
Bookmarks |
|
|