Trying to make Junky perhaps just a little bit Funky... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

msgross · 07-09-2014, 01:21 PM

I did this floor as well. Make sure that you take a lot of reference pics with measurements in them (hold up a tape measure).

I focused the bracing on the door frames since the middle will follow that area. cross brace in all three axis then lay cab on it's back to install the new floor. I drilled out the spot welds in the front and back and reused those holes for the new floor.

My 68 had extra braces under the gas tank that I don't see on yours, they also helped for allignment. i also used a lot of sheet metal screws to initial fitting

Good luck.

07-09-2014, 01:21 PM	#11
msgross Registered User Join Date: Jul 2006 Location: Central PA Posts: 12,201	Re: Trying to make Junky perhaps just a little bit Funky... I did this floor as well. Make sure that you take a lot of reference pics with measurements in them (hold up a tape measure). I focused the bracing on the door frames since the middle will follow that area. cross brace in all three axis then lay cab on it's back to install the new floor. I drilled out the spot welds in the front and back and reused those holes for the new floor. My 68 had extra braces under the gas tank that I don't see on yours, they also helped for allignment. i also used a lot of sheet metal screws to initial fitting Good luck. __________________ The Garage: 1968 K-10 SWB - "Project Money Pit" 1996 Z-71 - "huntin rig" 1969 C-10 LWB (SOLD) "Project flip that truck or else" 1993 Passport, F@rd 1-ton (SOLD)"Project Cousin Eddie" My Garage Build "The 1,000 footer"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.