Getting closer, have hydraulic clutch basically setup - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Yukon Jack** · 01-20-2004, 07:18 PM

Been getting work done on the truck slowly. Got the hydraulic clutch installation basically done last night. Buddy cut me the reinforcement for my firewall with his plasma cutter. Nice piece of equipment.

Another buddy made me the metal shim you see that positions the hydraulic cylinder correctly so the push rod will attach to the clutch pedal.

Got the cylinder mounted on the firewall, threaded the push rod and am using a 5/16" Heim joint to attach the rod to the clutch pedal. Cycles freely and the rod will push in as far as needed. Might have to make a stop to limit the clutch pedal.

Here are some pics.

01-20-2004, 07:18 PM	#1
Yukon Jack Post Whore Join Date: Feb 2000 Location: Rose Hill, KS, USA Posts: 12,684	Hydraulic clutch and Hydroboost install Been getting work done on the truck slowly. Got the hydraulic clutch installation basically done last night. Buddy cut me the reinforcement for my firewall with his plasma cutter. Nice piece of equipment. Another buddy made me the metal shim you see that positions the hydraulic cylinder correctly so the push rod will attach to the clutch pedal. Got the cylinder mounted on the firewall, threaded the push rod and am using a 5/16" Heim joint to attach the rod to the clutch pedal. Cycles freely and the rod will push in as far as needed. Might have to make a stop to limit the clutch pedal. Here are some pics. Attached Images __________________ 1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 Last edited by Yukon Jack; 01-16-2007 at 03:47 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.