Avoid the Concrete

[Low68]

You're welcome Swamp Rat. I am not sure if the hinges i had were factory. I would guess probably not. 3 of the 4 had plastic looking bushings in them. The fourth one had brass and a smaller diameter pin. I am pretty confident that the the fourth hinge was aftermarket. The first three were a piece of cake. Drilling out the fourth one wasn't as bad as i was expecting either.

I moved the truck onto the lift for the weekend so my dad could park his truck in the shop. I figured while i had it on there i would verify pinion angle. I also snapped a couple of pictures of the bottom of the chasis.



Lowest point on the truck is the bellhousing.