Rear Rollpan Questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

PrimeredThunder · 01-25-2004, 12:19 AM

I purchased a rear Rollpan for my 72' with the Fleetside box from Wes. When mocking up the pan before I weld it in I've noticed a few things. One, I need to trim about 3/16" off of each end for it to fit so I can weld it in. What's the best way to do this? Also, how am I supposed to access the lower bolt on the Tailgate hinges? It seems like I won't be able to get a wrench back behind there to tighten them down once its installed. Any help here would be great.

Thanks,

Kenny

01-25-2004, 12:19 AM	#1
PrimeredThunder Back from the Dead Join Date: Dec 2001 Location: Salem, Oregon Posts: 522	Rear Rollpan Install Questions I purchased a rear Rollpan for my 72' with the Fleetside box from Wes. When mocking up the pan before I weld it in I've noticed a few things. One, I need to trim about 3/16" off of each end for it to fit so I can weld it in. What's the best way to do this? Also, how am I supposed to access the lower bolt on the Tailgate hinges? It seems like I won't be able to get a wrench back behind there to tighten them down once its installed. Any help here would be great. Thanks, Kenny __________________ The only Carb that matters to me is the one under my hood! Salem, Oregon Last edited by PrimeredThunder; 01-25-2004 at 01:02 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.