ISO fuel filter with 5/16 flare fittings on both ends. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Longhorn 70 · 12-18-2014, 11:27 AM

I am cleaning up some of the plumbing under the hood and am looking for a fuel filter that I can make hard lines for. I envision female 5/16" flared fittings on each end. This way I can use the materials I have on hand. Has anyone seen one? Part numbers? I want to stay away from plastic and am leary of glass filters. I just don't like the way it looks now.

I called Fram and asked and the guy on the phone said I am out of luck.

OR is there a better way to run the fuel line from the pump to an Edelbrock carb?

Thanks in advance for the suggestions.

12-18-2014, 11:27 AM	#1
Longhorn 70 Registered User Join Date: Dec 2012 Location: Chandler AZ Posts: 1,149	ISO fuel filter with 5/16 flare fittings on both ends. I am cleaning up some of the plumbing under the hood and am looking for a fuel filter that I can make hard lines for. I envision female 5/16" flared fittings on each end. This way I can use the materials I have on hand. Has anyone seen one? Part numbers? I want to stay away from plastic and am leary of glass filters. I just don't like the way it looks now. I called Fram and asked and the guy on the phone said I am out of luck. OR is there a better way to run the fuel line from the pump to an Edelbrock carb? Thanks in advance for the suggestions. Attached Images __________________ 1970 Longhorn, Front Disc, 350/4 bolt, 882 heads, HEI, Edelbrock, 700R4, HO-52/4.11. 1996 Corvette, Collector Roadster, LT4, 396, 450RWHP, 6sp, 4.11/Dana44/posi 5 point roll bar And let us not grow weary of doing good, for in due season we will reap, if we do not give up. Gal 6:9



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.