CT WTB: Dash Pad (cracked ok), gas pedal, seat hardware, etc

[markmdz]

All for my '68 C20 LWB

My current short list is:

Dash Pad - As long as the clips and overall shape are ok, I don't care if the foam is a bit thrashed or the cover is split. I'm reupholstering it anyway, so I just need a good base and most of the foam so I can figure out the overall shape.

Gas Pedal - Same as dash pad... I don't care if it's ugly as long as it's not broken. Please include the pivot pin too.

Seat Hardware - I need the cable/rod, springs, spring clips, etc for the slider. I have the handle with knob and the brackets that go into the sliders, but no end hardware or the linking rod/cable. (I have another post looking for a couple seat springs too.)

Door Sills - Not sure I have the terminology correct, but i'm looking for the chrome/polished trim that goes in the bottom of the door sills to hold the carpet down. Driver quality is fine.

Taillight Harness - From the cab, back. Again, driver quality is fine. Honestly I'm fine with a harness that needs a little work as long as the wires aren't brittle. I will be going through every inch of wire on it to make sure there's no abrasions or gouges in it, replacing anything that's not perfect, and fully dressing it anyway, just need a decent base to start from with good plugs.

Front Bumper Brackets - Just need the inner brackets for the bumper to mount to the frame horns. I have mine, but one of the PO's snapped the bolt that holds the bracket to the frame on both, and I don't feel like drilling them out and re-tapping them.