MN 2003 Duramax 2500hd parting out

[Vintage Windmills]

Not much for small stuff, everything in cab or under hood got

I may be going to New mexico and could deliver a big part or two for gas money if you are on the route from there to MN. Thats not a sure thing, but am planning a trip at some point.

Parting out what was a nice dark grey truck until a fire started in the engine bay. There are still many good parts here. I will come down some in price if you take more than one thing on the list below. The interior is destroyed. Everything under the hood above front diff except intercooler and engine core is destroyed.

The top of the engine burned fairly bad, melting all the plastic and everything that wasn't metal. The inside of the cab was totally destroyed but the rear doors and front passenger faired well with minimal or no paint damage.

Truck had about 230k and is a LB7 core.

Allison 5spd auto trans worked good, just needs a shift position switch on the outside, no fire damage besides that $750
6.5 foot Bed- is rust free. just surface rust where the paint flaked in one spot down low. Rhino or LineX in very nice shape. Inside not beat up, no gooseneck hole. Not from a work truck! A couple minor dents $750 with tail lights. $700 without. SOLD
Nice tailgate, missing upper trim $200 SOLD
Rt rear dr $225, loaded but no interior panel SOLD
Rt frt dr $200, loaded but no interior panel SOLD
Lt rear dr $150, some paint damage. loaded but no interior panel SOLD
Cab SOLD
Spare tire SOLD
Rear bumper $100 just one small 1/2" depression,
good Transfer case $800 b/o
3.73 Frt axle (driver cv boots burned $150
fuel tank $50
driveshaft $75
hitch $50
11.5" Rear axle with G80 and good brakes $800
engine core unknown condition, water got in intake $650 b/o (oil looked good, was full when I drained after)
rims 3 good ones, some corrosion $150 total b/o
good frame $500 b/0
rear springs $100 each.

I will trade for a 4.10 AAM disc axle in 4.10 ratio, dana 44 front disc brake axle (71 chevy style). Also am interested in a low mile 350 V8 (must have receipts) or 5.3/6.0 Ls series, nv4500 out of cummins, 29 spline np205, and 91 to 93 silverado red bench seat in nice shape.

I have a tractor with a forklift and can load big items onto your truck and trailer.