Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-19-2015, 11:18 AM | #10 | |||
Senior Member
Join Date: Mar 2012
Location: Kansas City, MO
Posts: 2,018
|
Re: '57 Ford Custom 300 Tudor Sedan
Quote:
Quote:
Quote:
The rear seat is as done as it's going to get. The rest is up to the trim shop. If he says it needs anything else, I'll deal with it at that time. After all the slicing and dicing (fingers included) I decided to do something a bit easier. The custom dash bezels were just roughed in, so I test fit the components and laid down the carbon fiber pattern vinyl. Out at the edges of the dash where it curves around, I used a trick I learned from my sign painter buddy, Steve. To get a pattern off of an irregular surface, you build up multiple layers of masking tape then carefully transfer it to poster board. So you essentially transform a 3D surface to 2D. After trimming it, it can be used as a pattern for cutting the vinyl. In my case, I was also able to flip it over and use it for the driver side. Now that I've rested up on an easy peasy task, it's on to more challenging stuff. I need to finish mounting the pop locks, measure for the a/c lines, measure and route the trans cooler lines, build the radio rear support bracket and a whole host of other things. Stay tuned.
__________________
Victor 57 Chevy Wagon - California Dreamin'"Mecum'd" 9/2022 Dallas, TX Crusty Rusty Leaky Squeaky 67 Consigned 4/2019 Dresden, Germany Maybelline - my '57 Ford 2dr Sedan "Mecum'd" 3/2016 Location unknown Silver Streaker "Mecum'd" 4/2013 Somewhere in Texas |
|||
Bookmarks |
|
|